Rohde & Schwarz R&S ZNA Series - Page 1077

Command reference
R&S
®
ZNA
1077User Manual 1178.6462.02 ─ 29
Marker coupling is enabled using CALCulate:MARKer:COUPled[:STATe] ON.
Changing the coupling type automatically disables marker coupling throughout the
recall set.
Parameters:
<Type> ALL | CHANnel | DIAGram
Marker coupling mode
ALL
recall set-wide
CHANnel
channel-wide
DIAGram
diagram-wide
Example: See CALCulate:MARKer:COUPled[:STATe] on page 1076
Manual operation: See "Coupling Type" on page 521
CALCulate<Chn>:MARKer:DEFault:FORMat <OutFormat>
Defines the default marker format of the selected channel's active trace.
New markers will be formatted with the default marker format; previously existing mark-
ers will be reformatted if (and only if) their marker format is set to (Trace) DEFault
(using CALCulate<Chn>:MARKer<Mk>:FORMat).
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<OutFormat> MLINear | MLOGarithmic | PHASe | POLar | GDELay | REAL |
IMAGinary | SWR | LINPhase | LOGPhase | IMPedance |
ADMittance | DEFault | COMPlex | MDB | MLPHase |
MDPHase | MIMPedance | PIMPedance | PADMittance |
MADMittance | MPIMpedance | MPADmittance | INDX | NOISe
DEFault means the default marker format is dynamically adjus-
ted to the selected trace format (CALCulate<Chn>:FORMat).
For the other marker formats see the table below and the
description in "Marker format" on page 130.
*RST: DEFault
Manual operation: See "Dflt Marker Frmt " on page 425
SCPI GUI
MLINear "Lin Mag"
MLOGarithmic
MDB (for R&S ZVR compatibility)
"dB Mag"
PHASe "Phase"
SCPI command reference