Rohde & Schwarz R&S ZNA Series - 2.1.4 Firmware version 2.70

Welcome to the R&S ZNA
R&S
®
ZNA
20User Manual 1178.6462.02 ─ 29
2.1.4 Firmware version 2.70
New functionality
●
Power correction from pre-measurement
See Chapter 4.1.6, "Power correction from pre-measurement", on page 119
●
Time domain measurements (R&S ZNA-K2/K20): Time gates can be coupled
within the same channel
See "Time Gate Linking/Single Time Gate Linking" on page 455
●
New "Only Active Channel On" function to disable all channels except the active
one
See "Only Active Channel On" on page 655
●
Measurement uncertainty analysis (R&S ZNA-K50): Significance level can now be
configured
See "Significance" on page 644
Modified functionality
●
1.0 mm cal kit "Demo Kit 1 mm" renamed to "General alternative kit"
Note: To remove the "Demo Kit 1 mm" (leftover from previous firmware versions),
perform a factory preset.
●
Spectrum analysis (R&S ZNA-K1): For spectrum channels, "IF Filter (analog)" is
fixed to "Wideband", also when created using "Spectrum = Marker".
●
Two-tone group delay measurements (R&S ZNA-K9): Mixer delay calibration inte-
grated into standard calibration framework
– New calibration types "Mixer Delay" and "UOSM Mixer Delay" in calibration
GUI
– New calibration types MDELay | UMDelay | PUMDelay for remote calibra-
tion
– New remote command [SENSe<Ch>:]CORRection:COLLect:AUTO:
MDELay for delay mixer calibration
– Calibration-related controls removed from "Meas" > "Two Tone Group Dly" soft-
tool tab
●
R&S HUMS (R&S ZNA-K980) service updated to version 1.44
●
"OSP320-4-8NC" matrix definition aligned with R&S ZNrun V2.62
New remote control features
●
Additional commands for cal validation:
– CALCulate:CALValidate:AVERage[:STATe]
–
CALCulate:CALValidate:RESPonse:IMAGinary:LOWer|UPPer
–
CALCulate:CALValidate:RESPonse:REAL:LOWer|UPPer
– CALCulate:CALValidate:RUN:RESult?
Improvements
●
"Simulation Noise" can be toggled from the menu bar
●
Eye diagrams (R&S ZNA-K20: "Transfer Rate" can now be configured directly
See "Symbol Rate/Transfer Rate" on page 810
●
Cal validation: The format of the validation diagrams can now be configured
What's new in firmware version 2.74