GUI reference
R&S
®
ZNA
590User Manual 1178.6462.02 ─ 29
Remote command:
MMEMory:LOAD:CKIT
Mixer/IMD/Harmonics tab
Defines channel-specific settings for mixer and intermodulation (IMD) measurements.
Harmonic Orders to Calibrate
If a harmonics measurement is active in the current channel, this section allows you to
specify the harmonic orders to be calibrated in the current channel.
By default, the firmware selects all harmonic orders that are relevant for an existing
harmonics trace in this channel.
Remote command:
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer?
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:ADD
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:REMove
SOURce<Ch>:POWer<PhyPt>:CORRection:HARMonic[:ACQuire]
[SENSe<Ch>:]CORRection:POWer<PhyPt>:HARMonic:ACQuire
Cal softtool
To Next Page
Loading...
