GUI reference
R&S
®
ZNA
922User Manual 1178.6462.02 ─ 29
1. Use "Generic Device..." to open the External Generic Devices dialog, which allows
you to set up the VISA connection to the device and make it a part of the system
configuration.
2. Use "Generic Device Config..." to open the External Generic Device Config dialog,
which allows you to define the channel-specific command sequences that are sent
to the configured devices.
5.19.9.1 External Generic Devices dialog
The "External Generic Devices" dialog allows you to set up the communication to an
external VISA-capable device that is not natively supported by the analyzer firmware.
Access: System – [Setup] > "Generic Device" > "Generic Device..."
Background information
Refer to Chapter 4.7.42, "Generic devices", on page 331.
The configuration of a new generic device involves the following steps:
1. Connect the device to your R&S ZNA using a LAN (VXI-11), GPIB, or USB inter-
face.
2. If the device is connected via LAN, enable "LAN detection"
Setup softtool
To Next Page
Loading...
