GUI reference
R&S
®
ZNA
388User Manual 1178.6462.02 ─ 29
The settings in the channel mode setup dialog from which the "Frequency Overview"
dialog was called cannot be applied unless all measured frequency ranges are valid.
5.2.6.3 Intermodulation setup dialog (frequency-converting)
The frequency converting intermodulation setup dialog is an instance of the Multi-chan-
nel setup dialog. It allows you to set up one or more channels for an intermodulation
measurement on a frequency converting DUT.
Access: Trace – [Meas] ("Frequency Converting") > "Intermodulation" > "Intermod."
Figure 5-7: Intermodulation Setup Dialog (frequency converting DUT)
Meas softtool
To Next Page
Loading...
