GUI reference
R&S
®
ZNA
461User Manual 1178.6462.02 ─ 29
Remote command:
Compression point statistics:
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STARt
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STOP
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:SHOW
Power ratio statistics (spectrum analysis) :
CALCulate<Chn>:STATistics:RDOMain:USER
CALCulate<Chn>:STATistics:RDOMain:USER:STARt
CALCulate<Chn>:STATistics:RDOMain:USER:STOP
CALCulate<Chn>:STATistics:RDOMain:USER:SHOW
Defined Value
This setting is only visible if "Defined Value" is used as Reference Value. It manually
defines the reference value ("small signal value") for the compression point calculation.
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:RLEVel
CALCulate<Chn>:STATistics:NLINear:COMP:RPHase
5.5.8.2 Evaluation Range dialog
The "Evaluation Range" dialog defines the range for various trace evaluation opera-
tions (trace statistics, offset, loss and fixture compensation calculations). The evalua-
tion range is a continuous interval of the sweep variable.
Access:
●
Trace – [Trace Config] > "Trace Statistics" > "Evaluation Range..."
●
Channel – [Offset Embed] > "Offset" > "Evaluation Range..."
●
...
Traces softtool
To Next Page
Loading...
