GUI reference
R&S
®
ZNA
596User Manual 1178.6462.02 ─ 29
Remote command:
[SENSe<Ch>:]NFIGure:CALibration:GTIMe
5.11.1.5 Power Cal wizard
The "Power Cal" wizard displays a single screen, showing the current source and
receive ports. It allows you to perform "Ref. Receiver", "Meas. Receiver" and scalar
source power ("Source Flatness") calibrations, based on the current power calibration
settings (see Chapter 5.11.3, "Pwr Cal Settings tab", on page 626).
Access: Channel – [Cal] > "Start Cal" > "Power Cal..."
Screen elements
From top to bottom, the screen consists of the following elements.
Calibration Sweep Diagram
The calibration sweep diagram in the upper part of the screen shows the progress of
the calibration and the accuracy of a completed calibration ("Verification"). The diagram
is scaled in "dB Mag" format.
The diagram title indicates the ongoing calibration type and reading. The traces in the
diagram vary according to the calibration stage.
Cal softtool
To Next Page
Loading...
