GUI reference
R&S
®
ZNA
468User Manual 1178.6462.02 ─ 29
Exporting data from the firmware simulation
When working with the firmware simulation R&S ZNXSIM, make sure to deactivate
"Simulation Noise" before exporting traces to file. Otherwise the exported results com-
prise an "artificial" random component.
Since version 2.60 of the analyzer firmware, Simulation Noise can be activated or
deactivated from the analyzer GUI.
5.5.11.1 Import Complex Data dialog
The "Import Complex Data" dialog loads a memory trace from a trace file. Trace files
are ASCII files with selectable file format. The loaded trace data is used to generate a
memory trace which is coupled to the active data trace.
Access: Trace – [Trace Config] > "Trace Data" > "Import..."
Background information
Refer to Chapter 4.4.2, "Trace files", on page 176.
On loading data from a trace file with several traces, the analyzer displays a dialog to
select one or more of the traces stored in the file (see Chapter 5.5.11.3, "Select Param-
eter dialog", on page 473). E.g., for an *.s2p Touchstone file, the box offers all four 2-
port S-parameters (see Chapter 4.4.2.1, "Touchstone files", on page 177).
Coupling between the imported memory trace and the active data trace implies that the
stimulus values of the imported data and of the active trace must be compatible. Com-
patibility means that the "Sweep Type" of the two traces must match; the position and
number of the sweep points do not have to be the same.
The analyzer checks for compatibility before importing data. The "Select Parameter"
box remains empty if the selected file contains no compatible data.
"Import Complex Data" is a standard "Open File" dialog with an additional button.
Traces softtool
To Next Page
Loading...
