GUI reference
R&S
®
ZNA
435User Manual 1178.6462.02 ─ 29
●
Frequency Converting Measurements: see Chapter 5.2.13.2, "Frequency Convert-
ing Measurements dialog", on page 412
●
Two Tone Group Delay Measurements: see "Measurement" on page 417
5.5.1.3 Trace Manager dialog
The "Trace Manager" dialog allows you to perform operations on traces.
Access: Trace – [Trace Config] > "Traces" > "Trace Manager..."
All existing traces of the current recall set are listed in a table with several editable
(white) or non-editable (gray) columns.
Table Area
The table contains the following columns:
●
"Name" indicates name of the related trace.
Trace names must be unambiguous across all channels and diagram areas in a
recall set.
●
"On" indicates and controls the visibility of the related trace.
●
"Label" indicates and controls the visibility of the related trace label
●
"Meas" indicates the measured parameter.
●
"Type" indicates whether the trace is a data trace ("DAT"), displaying the current
measurement data, or a memory trace ("MEM").
●
"Channel" indicates and controls the channel to which the related trace is assigned.
Data traces and their associated memory traces are always assigned to the same
channel.
Traces softtool
To Next Page
Loading...
