GUI reference
R&S
®
ZNA
806User Manual 1178.6462.02 ─ 29
For additional settings, see Chapter 5.5.5, "Time Domain tab", on page 447.
Source/Receiver Settings
The "RF Power" is the output power of the R&S ZNA, "IF Bandwidth" and "Average
Factor" determine the operation of the related R&S ZNA receiver. For a description and
related remote control commands, see Chapter 5.9, "Pwr Bw Avg softtool",
on page 535.
DC Value
Defines how to calculate the DC gain of the DUT (since the R&S ZNA cannot measure
down to 0 Hz). These parameters are the same settings as for the standard time
domain option R&S ZNA-K2. For a description and related remote control commands,
see "DC Value" on page 452.
5.17.2.4 Eye Diag tab
The "Eye Diag" tab is for enabling and configuring the eye diagram and its measure-
ments.
Access: System – [Applic] > "TDR" > "Eye Diag"
Eye Diagram
The "Eye Diagram" checkbox enables the eye diagram with the current settings
(default or defined in Eye Diagram dialog) or disables it.
Remote command:
CALCulate<Chn>:EYE:STATe
Eye Diagram ...
Opens the Eye Diagram dialog that allows to create an eye diagram and to perform
basic settings on the simulated digital signal generator.
Applic softtool
To Next Page
Loading...
