Rohde & Schwarz R&S ZNA Series - 7.4.1 SNMP;REST commands

Command reference
R&S
®
ZNA
1672User Manual 1178.6462.02 ─ 29
7.4.1 SNMP/REST commands
These commands configure the SNMP and REST interfaces to R&S HUMS.
They all require software option R&S ZNA-980.
SYSTem:COMMunicate:SNMP:COMMunity:RO.............................................................. 1672
SYSTem:COMMunicate:SNMP:COMMunity:RW..............................................................1672
SYSTem:COMMunicate:SNMP:CONTact........................................................................1673
SYSTem:COMMunicate:SNMP:LOCation....................................................................... 1673
SYSTem:COMMunicate:SNMP:USM:USER....................................................................1673
SYSTem:COMMunicate:SNMP:USM:USER:ALL?........................................................... 1674
SYSTem:COMMunicate:SNMP:USM:USER:DELete........................................................ 1674
SYSTem:COMMunicate:SNMP:USM:USER:DELete:ALL................................................. 1674
SYSTem:COMMunicate:SNMP:VERSion........................................................................1674
SYSTem:COMMunicate:REST:ENABle...........................................................................1675
SYSTem:COMMunicate:SNMP:COMMunity:RO <CommunityString>
Defines the SNMP community string for read-only access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 1674).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set community name
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RO 'ABC'
Usage: Setting only
Manual operation: See "SNMPv2c Configuration" on page 872
SYSTem:COMMunicate:SNMP:COMMunity:RW <CommunityString>
Defines the SNMP community string for read-write access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 1674).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set read-write access
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RW 'ABC'
Usage: Setting only
Manual operation: See "SNMPv2c Configuration" on page 872
HUMS and service date commands