Rohde & Schwarz R&S ZNA Series - CALCulate:FMODel:EZD...

Command reference
R&S
®
ZNA
1033User Manual 1178.6462.02 ─ 29
CALCulate:FMODel:DELT:TDR <Boolean>
If the Time domain analysis option R&S ZNA-K2 is installed, this command allows you
to add the TDR-based converted impedance traces to the recommended trace configu-
ration.
Parameters:
<Boolean> OFF (0)
TDR-based impedance traces added
ON (1)
TDR-based impedance traces not added
*RST: OFF
Options: R&S ZNA-K231
Manual operation: See "Trace" on page 767
CALCulate:FMODel:EZD...
Commands for Eazy Deembedding (see Chapter 4.7.15, "Eazy de-embedding based
on IEEE 370", on page 298).
CALCulate:FMODel:EZD:COUPon:MEASure..................................................................1033
CALCulate:FMODel:EZD:COUPon:MEASure:FILename.................................................. 1034
CALCulate:FMODel:EZD:COUPon:MEASure:FILename:CLEar........................................ 1034
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe]........................................................ 1034
CALCulate:FMODel:EZD:DCEXtrapolat..........................................................................1034
CALCulate:FMODel:EZD:DUT:MEASure........................................................................ 1035
CALCulate:FMODel:EZD:DUT:MEASure:FILename.........................................................1035
CALCulate:FMODel:EZD:DUT:MEASure:FILename:CLEar...............................................1035
CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe]...............................................................1035
CALCulate:FMODel:EZD:GENerate:SIDE<1|2>.............................................................. 1036
CALCulate:FMODel:EZD:IMPedance.............................................................................1036
CALCulate:FMODel:EZD:IMPedance:BWIDlimit..............................................................1036
CALCulate:FMODel:EZD:IMPedance:REFerence............................................................1037
CALCulate:FMODel:EZD:PORT:ORDer..........................................................................1037
CALCulate:FMODel:EZD:PRESet..................................................................................1037
CALCulate:FMODel:EZD:RUN:RUN.............................................................................. 1037
CALCulate:FMODel:EZD<Pt>:RUN[:STATe]....................................................................1038
CALCulate:FMODel:EZD:COUPon:MEASure
For a fixture modeling with the Easy De-embedding (EZD) tool, this command starts
the measurement of the symmetrical 2xThru coupon at the active ports (see
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe] on page 1034).
Usage:
Event
Options: R&S ZNA-K210
Manual operation: See "Measure / Measure Open / Measure Short" on page 731
SCPI command reference