Rohde & Schwarz R&S ZNA Series - 7.3.14.9 [SENSe:]CORRection:METas

Command reference
R&S
®
ZNA
1395User Manual 1178.6462.02 ─ 29
Parameters:
<Type> Connector type (string parameter) of the connectors. See "Cal
kit naming conventions" under [SENSe:]CORRection:CKIT:
<ConnType>:SELect.
*RST: 'N 50 Ohm',FEM for all ports.
<Gender> MALE | FEMale
Gender of the connectors. The gender designation is not neces-
sary (and ignored) for sexless connector types.
Example:
*RST; :CORR:COLL:SCON1 'N 75 Ohm', MALE; SCON4?
Change the connector type at port 1 from 'N 50 Ohm', FEM to 'N
75 Ohm', MALE. The connector type at the other ports is also
changed to N 75 Ohm, however, the gender (female) is main-
tained. CORR:COLL:SCON4? returns 'N 75 Ohm', FEM.
Manual operation: See "Connector / Gender" on page 584
7.3.14.9 [SENSe:]CORRection:METas
Using [SENSe:]CORRection:METas commands you can define additional properties
of a METAS Calibration.
To perform a METAS calibration, use the standard commands for manual calibration
(see Chapter 7.3.14.10, "[SENSe:]CORRection... (other)", on page 1398). For the cali-
bration setup, use [SENSe<Ch>:]CORRection:COLLect:METHod:DEFine with
METAS calibration types MTOSm | MUOSm | MOSM | MTRL.
●
METAS calibration is not fully supported via remote control. The import of cal kits
with uncertainties must be performed from the analyzer GUI, and must be done
before the first METAS calibration.
[SENSe:]CORRection:METas:CABLe:CATalog?.............................................................. 1395
[SENSe<Ch>:]CORRection:METas:CABLe:MOVement....................................................1396
[SENSe<Ch>:]CORRection:METas:CABLe:REConnection............................................... 1396
[SENSe<Ch>:]CORRection:METas:CABLe:TYPE........................................................... 1396
[SENSe<Ch>:]CORRection:METas[:STATe].................................................................... 1397
[SENSe<Ch>:]CORRection:METas:UNCertainty............................................................. 1397
[SENSe:]CORRection:METas:CABLe:CATalog?
Lists the available METAS cable models, identified by their file names (without
*.cable extension) in the local METAS VNA Tools II database.
Usage:
Query only
Options: R&S ZNA-K50
Manual operation: See "Cable" on page 646
SCPI command reference