GUI reference
R&S
®
ZNA
909User Manual 1178.6462.02 ─ 29
5.19.7.1 Controls on the Switch Matrix tab
The buttons on the "Switch Matrix" tab open the following dialogs:
●
"Switch Matrix...", see Chapter 5.19.7.2, "External Matrices dialog", on page 909
●
"RF Connections...", see Chapter 5.19.7.4, "Switch Matrix RF Connections dialog",
on page 914
"RF Connections" is enabled if at least one switch matrix is configured.
Optimization
Allows you to select between different switch matrix routing optimizations:
●
"Speed" – switch as little as possible
●
"Precision" – always use the best possible route in terms of quality ("priority")
See Chapter 4.7.41.4, "Multiple paths: precision vs. speed", on page 327 for back-
ground information.
The selection is only enabled, if at least one of the connected switch matrices has mul-
tiple routes with non-identical priorities.
5.19.7.2 External Matrices dialog
The "External Matrices" dialog allows you to discover and register external switch
matrices.
Access: System – [Setup] > "External Ports" > "Switch Matrix..."
Background information
Refer to section Chapter 4.7.41, "External switch matrices", on page 323.
Setup softtool
To Next Page
Loading...
