Command reference
R&S
®
ZNA
1466User Manual 1178.6462.02 ─ 29
Example:
*RST; :SENSe:POWer:GAINcontrol:GLOBal MANual
Enable the manual configuration of independent GC settings for
each drive port.
SENSe:POWer:GAINcontrol:ALL LNO
Set the GC mode of all a and b wave receivers to "Low Noise".
Usage: Setting only
Manual operation: See "Set All Items to ..." on page 691
[SENSe<Ch>:]POWer:GAINcontrol:GLOBal <GCModesGlobal>
Globally configures the gain control (GC) in all receive paths (measurement receivers,
b-waves) for all analyzer ports or enables port-specific gain control configuration.
Suffix:
<Ch>
.
Channel number
Parameters:
<GCModesGlobal> LNOise | LDIStortion | MANual
LDIStortion
0 dB gain, for high input levels
LNOise
10 dB gain, for low input levels
MANual
Enables the manual configuration of independent wideband /
narrowband IF gain settings for each segment, drive port and
receiver. See [SENSe<Ch>:]POWer:GAINcontrol and
[SENSe<Ch>:]SEGMent<Seg>:POWer:GAINcontrol.
*RST: LDIS
Example: See [SENSe<Ch>:]POWer:GAINcontrol
Manual operation: See "Wb/Nb IF Gain" on page 677
7.3.14.18 [SENSe:]PULSe...
Pulsed measurements.
[SENSe<Ch>:]PULSe:ALC:MEASdelay..........................................................................1467
[SENSe<Ch>:]PULSe:ATIMe.........................................................................................1467
[SENSe<Ch>:]PULSe:COUPled[:STATe]........................................................................ 1467
[SENSe<Ch>:]PULSe:DUTYcycle..................................................................................1468
[SENSe<Ch>:]PULSe:FXDCycle[:STATe]....................................................................... 1468
[SENSe<Ch>:]PULSe:GENerator<Id>:DELay................................................................. 1469
[SENSe<Ch>:]PULSe:GENerator:PERiod...................................................................... 1469
[SENSe<Ch>:]PULSe:GENerator:SOURce.....................................................................1469
[SENSe<Ch>:]PULSe:GENerator<Id>[:STATe]................................................................ 1469
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:DATA.........................................................1470
[SENSe<Ch>:]PULSe:GENerator<Id>:TRAin:DELete:ALL................................................1470
[SENSe<Ch>:]PULSe:GENerator:TRAin:PERiod.............................................................1470
SCPI command reference
To Next Page
Loading...
