Rohde & Schwarz R&S ZNA Series - Controls in the Power Meter Transmission Coefficients dialog; Two Port Configuration dialog

GUI reference
R&S
®
ZNA
633User Manual 1178.6462.02 ─ 29
Controls in the Power Meter Transmission Coefficients dialog
Two Port Config...
These buttons open the "Two Port Configuration" dialog that allows you to define the
transmission coefficients of additional two-port devices between VNA and DUT (during
the measurement), and between VNA and power meter (during power calibration). See
"Two Port Configuration dialog" on page 633.
Remote command:
SOURce:POWer:CORRection:TCOefficient[:STATe]
Deprecated: SOURce<Ch>:POWer<PhyPt>:CORRection:TCOefficient:
CALibration
Two Port Configuration dialog
The "Two Port Configuration" dialog defines the transmission characteristics of an
additional two-port in the calibrated frequency range.
Access: Power Meter Transmission Coefficients dialog > "Two Port Config..."
Cal softtool