Welcome to the R&S ZNA
R&S
®
ZNA
21User Manual 1178.6462.02 ─ 29
See "Preferences" on page 612
Solved issues
●
Cal kits containing weights could not be exported
●
Time domain analysis R&S ZNA-K2:
– Selecting a different time domain transform ("Type" selection on "Time Domain"
tab) did not take effect
– Changing the permittivity did not change the distance in TDR distance plots
●
Distance to fault only worked for live traces
●
HP8720 parser emulation: Acquisition of calibration data for calibration type "Trans
Norm" was not initialized correctly
●
If measurement data is available for a calibration, and the related setup was saved
under a different name, then "Repeat Calibration" failed in the resulting recall set
●
If measurement data is available for a calibration of channel no. x and this calibra-
tion was stored to the cal pool, then "Repeat Calibration" failed if the related cal
pool calibration was applied to a channel no. y≠x
●
Eye diagrams (R&S ZNA-K20): changing "Advanced Settings" did not take immedi-
ate effect
●
"Delay" memory traces used the current stimulus axis instead of the stored one
●
Internal combiner (R&S ZNAxx-B212/B213) in "Combiner Configuration" dialog: It
was possible to select different receiver inputs for lower and upper tone
●
A memory trace with "Math" could not be recalled correctly if the original trace was
a wave
●
*RST always triggered a factory preset before loading a user preset file
2.2 Documentation overview
This section provides an overview of the R&S ZNA user documentation. Unless speci-
fied otherwise, you find the documents at:
https://www.rohde-schwarz.com/manual/ZNA
2.2.1 Getting started manual
Introduces the R&S ZNA and describes how to set up and start working with the prod-
uct. Includes basic operations, typical measurement examples, and general informa-
tion, e.g. safety instructions, etc.
A printed version is delivered with the instrument. A PDF version is available for down-
load on the Internet.
Documentation overview
To Next Page
Loading...
