Rohde & Schwarz R&S ZNA Series - 5.12.1.5 GPIO configuration; Basic GPIO configuration

GUI reference
R&S
®
ZNA
662User Manual 1178.6462.02 ─ 29
Remote command:
CONTrol<Ch>:RFFE<Bus>:TEST:CLOCk:RANGe
CONTrol<Ch>:RFFE<Bus>:TEST:CLOCk:SHUNt?
CONTrol<Ch>:RFFE<Bus>:TEST:DATA:RANGe
CONTrol<Ch>:RFFE<Bus>:TEST:DATA:SHUNt?
CONTrol<Ch>:RFFE<Bus>:TEST:VIO:RANGe
CONTrol<Ch>:RFFE<Bus>:TEST:VIO:SHUNt?
Set
Use the "Set" button to apply all RFFE configuration changes and to activate the con-
figured voltage and Range / Shunt settings on the RFFE pins.
Remote command:
CONTrol<Ch>:RFFE:TEST:OUTPut
Start Meas
Starts the voltage and current measurement.
Note that "Start Meas" does not automatically activate the "Output Voltage" and
"Range" / "Shunt" settings of the current channel. Use Set to activate them manually.
The measurement (=sampling) time can only be set via remote command. It is not
channel-specific and applies to RFFE and GPIO measurements.
Remote command:
CONTrol<Ch>:RFFE:TEST:SENSe:TRIGger
CONTrol<Ch>:RFFE:TEST:TIME
Voltage, Current
Results of the voltage/current measurements on the related RFFE pins.
Remote command:
CONTrol:RFFE<Bus>:TEST:DATA:VOLTage?
CONTrol:RFFE<Bus>:TEST:CLOCk:VOLTage?
CONTrol:RFFE<Bus>:TEST:VIO:VOLTage?
CONTrol:RFFE<Bus>:TEST:DATA:CURRent?
CONTrol:RFFE<Bus>:TEST:CLOCk:CURRent?
CONTrol:RFFE<Bus>:TEST:VIO:CURRent?
5.12.1.5 GPIO configuration
Access: GPIOs tab of the "RFFE Config" dialog
Basic GPIO configuration
The (left part of the) GPIO config table gives access to the channel-specific GPIO volt-
age settings.
Channel Config softtool