Rohde & Schwarz R&S ZNA Series - Page 1223

Command reference
R&S
®
ZNA
1223User Manual 1178.6462.02 ─ 29
CONTrol<Ch>:RFFE:TEST:SENSe:TRIGger
Starts the voltage/current measurements on all RFFE pins.
The measurement time can be defined using CONTrol<Ch>:RFFE:TEST:TIME.
Suffix:
<Ch>
.
Channel number
This suffix is ignored and can be omitted.
Usage: Event
Options: R&S ZN-B15/Z15 Var. 03
Manual operation: See "Start Meas" on page 662
CONTrol<Ch>:RFFE:TEST:TIME <MeasTime>
Sets the measurement time for the voltage/current measurements on the RFFE and
GPIO pins.
Same functionality as CONTrol<Ch>:GPIO:TIME.
Suffix:
<Ch>
.
Channel number
This suffix is ignored and can be omitted: the measurement time
is valid for all channels.
Parameters:
<MeasTime> Measurement (= sampling = averaging) time
Range: 95 μs to 100 ms
*RST: 100 ms
Default unit: s
Options: R&S ZN-B15/Z15 Var. 03
Manual operation: See "Start Meas" on page 662
CONTrol<Ch>:SEGMent<SegNr>:SEQuence<SeqNr>:DELay <Delay>
For segmented sweeps this command allows to introduce delays between subsequent
sequence steps and between the final sequence step and the sweep (segment) start.
The command/switch sequences are defined using CONTrol<Ch>:
SEGMent<SegNr>:SEQuence<SeqNr>:RFFE<Bus>:COMMand:DATA and
CONTrol<Ch>:SEGMent<SegNr>:SEQuence<SeqNr>:GPIO<Port>:VOLTage.
Suffix:
<Ch>
.
Channel number
<SegNr> Segment number
SCPI command reference