Rohde & Schwarz R&S ZNA Series - 7.3.1.2 CALCulate:DATA...

Command reference
R&S
®
ZNA
975User Manual 1178.6462.02 ─ 29
Usage: Query only
Manual operation: See "Validate" on page 610
CALCulate:CALValidate:STANdard <Standard>
Selects the CalU standard to be used for cal validation.
Parameters:
<Standard> OPEN | SHORt | MATCh
7.3.1.2 CALCulate:DATA...
The CALCulate:DATA... commands provide access to the results of a measure-
ment.
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the FORMat[:DATA] setting. If block data format is used, it is recommended to
select EOI as a receive terminator (SYSTem:COMMunicate:GPIB[:SELF]:
RTERminator EOI).
CALCulate<Chn>:DATA..................................................................................................975
CALCulate:DATA:ALL?................................................................................................... 978
CALCulate<Ch>:DATA:CALL...........................................................................................979
CALCulate<Ch>:DATA:CALL:CATalog?............................................................................980
CALCulate<Ch>:DATA:CHANnel:ALL?.............................................................................980
CALCulate<Ch>:DATA:CHANnel:DALL?.......................................................................... 980
CALCulate:DATA:DALL?.................................................................................................981
CALCulate<Ch>:DATA:MDATa:INTerpolate.......................................................................981
CALCulate<Chn>:DATA:NSWeep:COUNt?.......................................................................981
CALCulate<Chn>:DATA:NSWeep:FIRSt?......................................................................... 982
CALCulate<Chn>:DATA:NSWeep[:LAST]?....................................................................... 983
CALCulate<Ch>:DATA:SGRoup?.................................................................................... 983
CALCulate<Chn>:DATA:STIMulus?................................................................................. 984
CALCulate:DATA:TRACe................................................................................................ 984
CALCulate<Chn>:DATA <Format>, <Data>...
CALCulate<Chn>:DATA? <Format>
The query reads the response values of the selected channel's active trace or reads
error terms of the selected channel.
The "set command" either imports formatted or unformatted trace data to the selected
channel's active trace (see Chapter 4.1.7, "Data flow", on page 120) or writes error
terms of the selected channel.
SCPI command reference