Rohde & Schwarz R&S ZNA Series - Page 981

Command reference
R&S
®
ZNA
981User Manual 1178.6462.02 ─ 29
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
Return values:
<Data> Trace data either in ASCII or block data format, depending on
the current FORMat[:DATA] setting.
Usage: Query only
CALCulate:DATA:DALL? <Format>
Reads the current response values of all data traces of the current recall set. Use
CALCulate:DATA:ALL? to query data traces and memory traces.
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
Return values:
<Data> Response values either in ASCII or block data format, depend-
ing on the current FORMat[:DATA] setting.
Example: Analogous to CALCulate:DATA:DALL?; see
CALCulate<Chn>:DATA.
Usage: Query only
CALCulate<Ch>:DATA:MDATa:INTerpolate
Uses linear inter-/extrapolation to "regrid" all memory traces of the related channel to
the channel's current stimulus values.
Suffix:
<Ch>
.
Channel number
Usage: Event
CALCulate<Chn>:DATA:NSWeep:COUNt?
Reads the number of completed sweeps in single sweep mode (INITiate<Ch>:
CONTinuous OFF). The trace can be any of the traces acquired during the single
sweep cycle.
Tip:
This command can only be used for [SENSe<Ch>:]SWEep:COUNt > 1.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference