GUI reference
R&S
®
ZNA
764User Manual 1178.6462.02 ─ 29
The deembedding of single-ended and decoupled ports is assigned as Single Ended,
the deembedding of balanced ports as Balanced, and the deembedding of coupled as
Port Sets deembedding.
Remote command:
CALCulate:FMODel:DEASsistant:IMPCorrect
CALCulate:FMODel:DEASsistant:DUT:PORT
CALCulate:FMODel:DEASsistant:DUT:MEASure
CALCulate:FMODel:DEASsistant:RUN
5.14.12 Delta-L tab
The controls on the "Delta-L" tab allow you to set up and perform a Delta-L PCB char-
acterization.
The "Delta-L" tab is only visible if option R&S ZNA-K231 is installed on the instrument.
See Chapter 4.7.18, "Delta-L 4.0 PCB characterization", on page 300.
●
The "Delta-L Settings..." button opens the Delta-L Settings dialog, which allows you
to configure a Delta-L measurement.
●
The "Delta-L Measurement" button runs the configured measurement.
●
The "Balanced Ports..." button opens a dialog that allows you to enable/disable
physical ports and to define logical ports (balanced or unbalanced) in the active
channel. See Chapter 5.2.2.5, "Balanced Ports dialog", on page 352.
If either multiple DUTs are configured (see Chapter 5.12.2.3, "Define Parallel Measure-
ment dialog", on page 682) or the "Fixture Simulator" is disabled for the related chan-
nel (see "Fixture Simulator" on page 655), the "Balanced Ports..." button is inactive
(grayed out).
5.14.12.1 Delta-L Settings dialog
From the "Detal-L Settings" dialog, you can set up the Delta-L measurement channel
and how the external tool is run.
Access: Channel – [Offset Embed] > "Delta-L" > "Delta-L Settings..."
Offset Embed softtool
To Next Page
Loading...
