Rohde & Schwarz R&S ZNA Series - 7.3.10 MEMory commands

Command reference
R&S
®
ZNA
1269User Manual 1178.6462.02 ─ 29
ON | 1 (setting) – adds all registered switch matrices to the RF
configuration, performing a default assignment of VNA ports and
test ports.
OFF | 0 (setting) – removes all switch matrices from the RF con-
figuration
1 (query) – at least one RF connection to a switch matrix
0 (query) – no RF connection to a switch matrix
Example: See SYSTem:COMMunicate:RDEVice:SMATrix:
CONFigure:STARt
INSTrument:TPORt:COUNt?
Returns the total number of test ports.
Because the R&S ZNA doesn't support switch matrices, this is always the same as the
number of analyzer ports (see INSTrument:PORT:COUNt?).
In absence of switch matrices, i.e. if no RF connection to a switch matrix is configured,
this is identical to the number of VNA ports (see INSTrument:PORT:COUNt?).
With switch matrices, the return value is the total number of matrix test ports plus the
number of VNA ports that are not connected to a switch matrix.
Usage:
Query only
7.3.10 MEMory commands
The MEMory... commands control the loaded recall sets of the analyzer.
Storing setups
The MEMory... commands do not affect any stored files. Use the MMEMory... com-
mands to store and load data and to manage files stored on a mass storage device.
MEMory:CATalog?....................................................................................................... 1269
MEMory:CATalog:COUNt?............................................................................................ 1270
MEMory:DEFine.......................................................................................................... 1270
MEMory:DELete:ALL....................................................................................................1270
MEMory:DELete[:NAME].............................................................................................. 1270
MEMory:SELect...........................................................................................................1271
MEMory:CATalog?
Returns the names of all loaded recall sets.
SCPI command reference