GUI reference
R&S
®
ZNA
563User Manual 1178.6462.02 ─ 29
Figure 5-19: Example of a multiple trigger configuration
The table in the "Trigger Manager" dialog contains several editable (white) or non-edit-
able (gray) columns. All settings are analogous to the general trigger settings in the
Trigger tab. Refer to the following sections:
●
"Sequence" on page 561
●
"Source" on page 562
●
"FreeRun / External / Manual / Multiple Triggers" on page 560
●
"Signal Type" on page 562
●
"Delay" on page 562
... /Logic/ ...
The table defines all settings related to "Multiple Triggers". For all measurement
sequences it is possible to select (and configure) the related trigger logic:
●
no trigger required ("Free Run")
●
a single trigger source with configurable Signal Type
●
a logical combination of two trigger sources, each with configurable "Signal Type"
Remote command:
TRIGger<Ch>[:SEQuence]:MULTiple:SOURce<inp>
TRIGger<Ch>[:SEQuence]:MULTiple:LOGic
TRIGger<Ch>[:SEQuence]:MULTiple:SLOPe<Num>
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff
5.10.4.3 Trigger Out Manager dialog
Defines if and how the channel-specific sweep sequence is indicated at the Trigger Out
interfaces.
Access: Channel – [Sweep] > "Trigger" > "Trigger Out Manager..."
Sweep Softtool
To Next Page
Loading...
