GUI reference
R&S
®
ZNA
565User Manual 1178.6462.02 ─ 29
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:DURation
Position
If pulses are used as trigger out signals (see "Signal Type" on page 564), the pulses
can either indicate the "Start" or "End" position of the related sweep event (see
"Sequence" on page 564). Choose the suitable position setting according to the action
to be triggered.
Note that for the "Pulse Generator" Sequence only the "Start" position can be used.
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:POSition
5.10.5 Sweep Control tab
Allows you to control the sweep execution.
The availability of certain settings depends on the selected Remote Language.
5.10.5.1 Controls on the Sweep Control tab
Continuous / Single
Activate either continuous (default) or single sweep mode.
●
In "Continuous" sweep mode, the analyzer measures the related channel (or chan-
nels) continuously, repeating the current sweep over and over.
Sweep Softtool
To Next Page
Loading...
