Rohde & Schwarz R&S ZNA Series - 5.11.1.3 Calibration wizard

GUI reference
R&S
®
ZNA
573User Manual 1178.6462.02 ─ 29
●
"Power Cal Only" section
The "Scalar Power Cal" button opens the Power Cal wizard, which allows you to
perform "Ref. Receiver", "Meas. Receiver" and scalar source power ("Source Flat-
ness") calibrations for the current channel.
Guided Calibration...
Use "Start... (Guided)" to open the Guided Calibration wizard that allows you to config-
ure and run a set of calibrations efficiently.
Cal Validation ...
Opens the Cal Validation dock widget that allows you to set up and run a Calibration
validation.
5.11.1.3 Calibration wizard
Guides you through the acquisition of calibration data (system error correction and
power correction).
Access:
●
Channel – [Cal] > "Start Cal" > "Cal Active Channel" – "Quick Start Calibration"
●
Calibration setup dialog > "Start Cal"
●
Channel – [Cal] > "Start Cal" > "Calibrate All" – "Quick Start Calibrate All"
●
Calibrate All dialog > "Start Cal"
If accessed via "Quick Start Calibration" or the calibration setup dialog, a single chan-
nel is calibrated. If accessed via "Quick Start Calibrate All" or the "Calibrate All" dialog,
possibly multiple channels are calibrated. Depending on the calibration setup, the cali-
bration can also involve several power calibration steps.
Cal softtool