GUI reference
R&S
®
ZNA
376User Manual 1178.6462.02 ─ 29
5.2.5.3 NF quickset dialog
The "Quickset" dialog guides you through to setup of a noise figure (NF) measurement.
Access:
●
Noise Figure tab ("S-Params") > "Quick Setup Noise Figure" tool button
●
Noise figure setup dialog (non-frequency-converting) > "Quickset" tool button
If external switch matrices are used, the quickset functionality is not available and
hence this dialog cannot be accessed.
Figure 5-5: NF Quickset dialog
The dialog provides guidance in terms of optimized measurement configuration and
calculates the required measurement and calibration settings, such as source power
and detector times.
Meas Settings
The controls in the "Meas Settings" section allow you to enter the start and stop fre-
quency of the NF measurement, and the number of frequency sweep points.
Meas softtool
To Next Page
Loading...
