GUI reference
R&S
®
ZNA
781User Manual 1178.6462.02 ─ 29
Tip: The printer settings are not affected by a preset of the R&S ZNA. Use the
"Remote" tab in the System Config dialog to restore default settings.
5.15.5 Trace Data tab
See Chapter 5.5.11, "Trace Data tab", on page 467.
5.15.6 More tab
The buttons on the "More" tab allow you to load simulation data or close the VNA appli-
cation.
Loading simulation data and adding simulation noise is only available for the PC firm-
ware simulation (see Chapter 4.7.45, "R&S ZNXSIM", on page 335).
Load Simulation Data...
Imports simulation data into the current setup.
The analyzer opens the "Load Simulation Data" dialog that lets you select a trace file
(*.sNp, *.csv, *.dat). As an option, you can load the simulation data into the
"Active Channel Only", allowing you to analyze different simulation data in different
channels of a setup.
Tip: Using the standard trace file export functionality, the loaded data can be converted
to different formats.
File Print softtool
To Next Page
Loading...
