Rohde & Schwarz R&S ZNA Series - Noise Figure tab

GUI reference
R&S
®
ZNA
594User Manual 1178.6462.02 ─ 29
Remote command:
[SENSe<Ch>:]CORRection:ADVanced:SENSe<PhyPt>:PREamp
[SENSe<Ch>:]CORRection:ADVanced:SENSe<PhyPt>:PREamp:STATe
Receiver Step Att
Receiver step attenuation used during calibration, if activated.
Only available for ports that are equipped with receiver step attenuators (see Chap-
ter 4.7.31, "Receiver step attenuators", on page 309).
Remote command:
[SENSe<Ch>:]CORRection:ADVanced:SENSe<PhyPt>:PREamp
[SENSe<Ch>:]CORRection:ADVanced:SENSe<PhyPt>:PREamp:STATe
Parameter Source Flatness
Specifies the parameters of a source flatness calibration. See Chapter 5.11.3, "Pwr Cal
Settings tab", on page 626.
Reference Receiver Cal Power
See "Reference Receiver Cal Power" on page 631.
Noise Figure tab
In this tab, you can adjust noise figure calibration settings such as power levels and
detector times.
Cal softtool