GUI reference
R&S
®
ZNA
706User Manual 1178.6462.02 ─ 29
Amplitude > Port / Start Power / Stop Power ← Imbalance Sweep Settings ← True
Differential Mode
Configures the amplitude imbalance sweep type in true differential mode:
●
"Port" selects the balanced logical port to be swept
●
"Start Power" and "Stop Power" define the amplitude difference at the start/stop of
each sweep
Remote command:
SOURce<Ch>:TDIF:IMBalance:AMPLitude:LPORt
SOURce<Ch>:TDIF:IMBalance:AMPLitude:STARt
SOURce<Ch>:TDIF:IMBalance:AMPLitude:STOP
Topology (graphical button)
Visualizes the logical port configuration. If the Balanced Ports dialog is not already in
the background, you can open it from here.
5.14 Offset Embed softtool
The "Offset Embed" softtool allows you to define a length offset and loss for each test
port. The offset compensates for the known length and loss of (non-dispersive and per-
fectly matched) transmission lines between the calibrated reference plane and the
DUT. It also contains advanced functions for deembedding/embedding the DUT from/
into more general physical/virtual (matching) networks placed between the calibrated
reference plane and the DUT.
Access: Channel – [Offset Embed]
Background information
Refer to Chapter 4.6, "Offset parameters and de-/embedding", on page 228
5.14.1 Offset Embed dock widget
On activating a tab in the "Offset Embed" softtool, a dock widget is displayed beneath
the trace area, whose content pane is synchronized with the selected softtool tab.
Access: Channel – [Offset Embed]
5.14.1.1 Overview panel
Shows an overview of the overall calculation flow and provides quick access to the
"Offset Embed" functions.
Access: Channel – [Offset Embed] > "Overview"
Offset Embed softtool
To Next Page
Loading...
