GUI reference
R&S
®
ZNA
734User Manual 1178.6462.02 ─ 29
5.14.5.4 Save Fixture Model
This section allows you to run the selected deembedding tool to generate the Touch-
stone files for fixture deembedding (and the Touchstone file of the de-embedded DUT).
Figure 5-44: Save Fixture Model section
left = single-ended
right = balanced
Run <Fixture Modeling Tool>
Runs the selected fixure deembedding tool.
This button is only active, if both:
●
the test coupon measurement finished successfully or the test coupon data were
successfully loaded from file (see Chapter 5.14.5.2, "Measure Coupon",
on page 730)
●
the measurement of DUT + test fixture finished successfully (see Chapter 5.14.5.3,
"Measure DUT + Test Fixture", on page 732)
The resulting Touchstone files (S parameters of the lead-ins, the lead-outs, and the de-
embedded DUT) are written to C:\Users\Public\Documents\Rohde-Schwarz\ZNA
\Embedding. If result files with the same names already exist, you can decide whether
you want to rename or overwrite them.
If running the deembedding tool causes errors, the <Deembedding Tool> Errors dialog
provides additional information.
Offset Embed softtool
To Next Page
Loading...
