Rohde & Schwarz R&S ZNA Series - Service tab

GUI reference
R&S
®
ZNA
880User Manual 1178.6462.02 ─ 29
Remote command:
TRIGger[:SEQuence]:LTRigger:COUNt?
Clear Lost Trigger Log
Does what it says. Also resets the lost trigger counter.
Remote command:
TRIGger[:SEQuence]:LTRigger:RESet
TRIGger[:SEQuence]:LTRigger:COUNt?
Activate Lost Trigger
Activates/deactivates tracking of lost trigger events.
Remote command:
TRIGger[:SEQuence]:LTRigger[:STATe]
Service tab
Allows you to read or specify service-related information. This information can be read
via R&S HUMS, however, it does not require the corresponding option R&S ZNA-K980.
Next Calibration Due
The date (and time) the instrument needs calibration to be done.
Remote command:
DIAGnostic:SERVice:CALibration:DUE:DATE
Recommended Calibration Interval
Queries the recommended calibration interval, set by Rohde&Schwarz service.
Remote command:
DIAGnostic:SERVice:CALibration:INTerval?
Last Service
The last date (and time) the instrument was serviced.
Typically set by Rohde&Schwarz service.
Remote command:
DIAGnostic:SERVice:DATE
Setup softtool