EasyManua.ls Logo

Rohde & Schwarz R&S ZNA Series - 7.3.15 SOURce commands; 7.3.15.1 SOURce:CMODe...

Rohde & Schwarz R&S ZNA Series
1849 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command reference
R&S
®
ZNA
1521User Manual 1178.6462.02 ─ 29
Example:
SENSe:UDSParams:ACTive OFF
resolves all redefined ports
SENSe:UDSParams1:PARam '1:b2:b3'
redefines physical port 1 as source = (original) physical port 1,
reference receiver = physical port 2, measurement receiver =
physical port 3
SENSe:UDSParams:ACTive?
returns 1 (= ON; see [SENSe:]UDSParams:ACTive)
Manual operation: See "a wave, b wave, Source" on page 920
7.3.15 SOURce commands
The SOURce... commands affect the source settings of the R&S ZNA.
Port-specific and general settings
The SOURce... subsystem comprises channel-specific and general settings. Chan-
nel-specific settings are valid for the channel specified by the numeric suffix <Ch>
(SENSe<Ch>:...). General settings are valid for all channels; the channel suffix is
ignored. Refer to the description of the individual commands for more information.
7.3.15.1 SOURce:CMODe...
The SOURce:CMODe commands enable and configure Phase coherent source control
(R&S ZNA-K6).
SOURce<Ch>:CMODe:OPTimized[:STATe].................................................................... 1521
SOURce<Ch>:CMODe:PORT<Pt>:PHASe.....................................................................1522
SOURce<Ch>:CMODe:PORT<Pt>:PHASe:SPAN........................................................... 1522
SOURce<Ch>:CMODe:PORT<Pt>[:STATe].................................................................... 1522
SOURce<Ch>:CMODe[:STATe]..................................................................................... 1523
SOURce<Ch>:CMODe:WCORrection[:STATe]................................................................ 1523
SOURce<Ch>:CMODe:OPTimized[:STATe] <Boolean>
Allows to select between optimized and raw phase control in source coherence mode
(see SOURce<Ch>:CMODe[:STATe] on page 1523).
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> ON
Optimized phase control, applying port match corrections
and.calibration (ON, default)
OFF
Raw phase control
Options: R&S ZNA-K6
SCPI command reference

Table of Contents

Related product manuals