Rohde & Schwarz R&S ZNA Series - 5.10.5.2 Restart Manager dialog

GUI reference
R&S
®
ZNA
568User Manual 1178.6462.02 ─ 29
The possible sweep stages and how they are displayed partly depend on the selected
sweep mode (see "Continuous / Single" on page 565):
Sweep stage Sweep controller display
in "Continuous" sweep
mode
in "Single" sweep mode
No ongoing sweep Idle Idle
Sweep is being prepared Preparing Preparing
Ongoing sweep
1)
Continuous Sweeping
if #Sweeps = 1
Sweeping m/n
if n = #Sweeps > 1
Measurement results are being calculated Continuous calculation Calculation
1)
The VNA is sweeping or waits for a trigger signal.
5.10.5.2 Restart Manager dialog
The "Restart Manager" dialog defines the Restart Sweep behavior in "Single" sweep
mode.
Access: Channel – [Sweep] > "Sweep Control" > "Restart Manager..."
Related information
Refer to Chapter 4.1.4, "Sweep control", on page 110.
Sweep Softtool