Getting Started
R&S
®
ZNA
41User Manual 1178.6462.02 ─ 29
●
external measurement equipment such as calibration units, power meters, fre-
quency converters, extension units, signal generators, or switch matrices
3.2.2 Rear panel
This section gives an overview of the rear panel elements of the network analyzer.
1
2 3 4 5 6
7
8 9 10
11
12
13
14
15
17
18
19
21
22
16
Table 3-2: Rear panel elements available on all instruments
Index Label Description
1 System Drive Removable system drive of the R&S ZNA, containing all software (including the operating
system and the VNA application) and data. No other drive is built in. Do not remove the
system drive during operation.
Option R&S ZNA-B19 provides an additional removable system drive (including operating
system and firmware).
2 Display Port External monitor connector (DisplayPort); see Chapter 3.1.11.1, "Connecting a monitor",
on page 32.
3 DVI Digital only External monitor connector (DVI-D); see Chapter 3.1.11.1, "Connecting a monitor",
on page 32.
4 LAN RJ-45 connector to integrate the instrument to a Local Area Network, primarily for remote
control purposes; see Chapter 12.1.2.1, "Assigning an IP address", on page 1775.
See also Chapter 12.3.2, "LAN interface", on page 1781.
5 USB Type A USB host (master) connectors. Similar functionality as the USB connectors on the
front panel (see "USB connectors" on page 40).
Instrument tour
To Next Page
Loading...
