GUI reference
R&S
®
ZNA
890User Manual 1178.6462.02 ─ 29
Advanced ...
Opens a dialog that allows to set the following parameters:
●
"Wait for Data after Sweep" determines the execution behavior of
INITiate[:IMMediate] commands (see Chapter 7.3.8, "INITiate commands",
on page 1265).
If enabled, an automatic *WAI is added (see Chapter 7.2, "Common commands",
on page 970).
By default this is disabled.
●
"Auto-Align Logical Ports" determines the logical port creation logic.
If enabled (default), logical ports are aligned and must be set from low to high port
(which was the only possibility prior to firmware V1.91). If set to disabled, new ports
can be created freely, like in manual operation.
●
"No Device Clear" suppresses Device Clear (DCL, SDC) GPIB interface mes-
sages.
Remote command:
SYSTem:COMMunicate:GPIB[:SELF]:INIT:WAIT
SYSTem:COMMunicate:GPIB[:SELF]:LPORt:ALIGn
SYSTem:COMMunicate:GPIB[:SELF]:DCLear:SUPPress
Instrument Messages...
Opens the System Configuration dialog with the Messages tab selected. From there
you can configure the display of instrument messages as information popups, in partic-
ular the display of remote control command errors.
5.19.4 Power Meter tab
Allows you to set up and configure power meters and to enable error logging for the
current session.
Remote control via GPIB
The built-in GPIB interface can be used to control external devices. An additional USB-
to-IEC/IEEE adapter is only required in case you want to control the R&S ZNA via
GPIB at the same time..
Setup softtool
To Next Page
Loading...
