GUI reference
R&S
®
ZNA
891User Manual 1178.6462.02 ─ 29
5.19.4.1 Controls on the Power Meter tab
The buttons in the "Power Meter" tab open the following dialogs:
●
"Power Meters...", see Chapter 5.19.4.2, "External Power Meters dialog",
on page 891
●
"Power Meter Config...", see Chapter 5.19.4.3, "External Power Meter Config dia-
log", on page 895
This button is active only if at least one external power meter is online (physically
connected, switched on, ready to be used).
Log Errors
Enables the transfer of error messages for external devices (e.g. connection errors) to
the error log. The error log appears in the "Info" dialog; see Chapter 5.19.1.3, "Info dia-
log", on page 874.
Remote command:
n/a
5.19.4.2 External Power Meters dialog
The "External Power Meters" dialog configures external power meters so that they can
be used for measurements and power calibrations.
Access: System – [Setup] > "Power Meter" > "Power Meters..."
Background information
Refer to section Chapter 4.7.39, "External power meters", on page 316.
Setup softtool
To Next Page
Loading...
