Rohde & Schwarz R&S ZNA Series - 5.15.4 Printer Setup dialog; 5.15.4.1 Content tab

GUI reference
R&S
®
ZNA
779User Manual 1178.6462.02 ─ 29
5.15.4 Printer Setup dialog
The "Printer Setup" dialog specifies how the diagram content of, and/or other informa-
tion on the active recall set is printed. Printer options are specified in three tabs. The
lower part of the dialog shows a preview of the print.
Access: System – [File Print] > "Print" > "Print..."
The HCOPy... commands provide the printer settings; see Chapter 7.3.7, "HCOPy
commands", on page 1259.
5.15.4.1 Content tab
The "Content" tab allows you to select the diagram content to be printed.
The selected item in the " Print Charts" group specifies how the diagram area of the
active recall set is printed. Currently the following options are offered: "No Diagram at
File Print softtool