Rohde & Schwarz R&S ZNA Series - 7.3.15.2 SOURce:FREQuency...

Command reference
R&S
®
ZNA
1523User Manual 1178.6462.02 ─ 29
Parameters:
<Boolean> *RST: OFF
Example:
*RST; SOUR:CMOD:PORT3 ON
Reset the analyzer and define the source signal of port 3 as
coherent.
SOUR:CMOD:PORT3:PHAS 90
Assign 90° phase to the voltage of the coherent signal at port 3.
SOUR:CMOD ON
Turn source coherence on.
Options: R&S ZNA-K6
Manual operation: See "Def'd Phase Coherence" on page 704
SOURce<Ch>:CMODe[:STATe]
<Boolean>
Turns source coherence mode (globally) on or off. Defined coherence for individual
analyzer ports is enabled or disabled using SOURce<Ch>:CMODe:PORT<Pt>[:
STATe].
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: Off (0)
Options: R&S ZNA-K6
Manual operation: See "Source Coh. On" on page 703
SOURce<Ch>:CMODe:WCORrection[:STATe] <Boolean>
Same functionality as [SENSe<Ch>:]CORRection:EWAVe[:STATe].
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: On (1)
Options: R&S ZNA-K6
Manual operation: See "Apply Wave Correction" on page 703
7.3.15.2 SOURce:FREQuency...
The SOURce:FREQuency... commands configure the sources for frequency conver-
sion measurements and control the frequency and power of the internal signal source.
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:EFRequency<Gen>............... 1524
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:IFRequency...........................1525
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed.................................................1527
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMODe.................................................. 1527
SCPI command reference