GUI reference
R&S
®
ZNA
913User Manual 1178.6462.02 ─ 29
Remote command:
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:SERial?
Delete All
Unregisters all switch matrices, automatically deleting all switch matrix RF connections.
Remote command:
SYSTem:COMMunicate:RDEVice:SMATrix:DELete
5.19.7.3 Device LAN Configuration dialog
The "Device LAN Configuration" dialog allows you to read and to modify the "IP Config-
uration" of an external device that is equipped with a LAN interface.
Access: External Matrices dialog > "Configure"
Because the IP configuration is written to the device, the device must be online for the
settings to be applied.
Uncheck "Manual Configuration" if you want the device to discover its host configura-
tion via DHCP. In this case only the device's "Hostname" can be specified.
In "Manual Configuration" mode also the unit's "IP Address", "Subnet Mask" and "Stan-
dard Gateway" can be set. If the unit is located in the same subnet as the analyzer,
Setup softtool
To Next Page
Loading...
