GUI reference
R&S
®
ZNA
382User Manual 1178.6462.02 ─ 29
– upper IM7
– upper IM9
●
"CW Mode"
Activates a new channel for the spectrum measurement. The "CW Frequency" plus
half the "Tone Distance" defines the center of the diagram.
●
"Spectrum = Marker"
This button is only available if the analyzer is equipped with software option
R&S ZNA-K1; see "Spectrum = Marker" on page 506. If there is no marker in the
active intermodulation trace, the center frequency of the related channel is used.
●
"Max IM Order"
Defines the width of the spectrum measurement.
Remote command:
[SENSe<Ch>:]FREQuency[:CW]
[SENSe<Ch>:]FREQuency:IMODulation:MSPectrum
[SENSe<Ch>:]FREQuency:IMODulation:SPECtrum:MORDer
[SENSe<Ch>:]FREQuency:IMODulation:SPECtrum[:STATe]
5.2.6.2 Intermodulation setup dialog
The intermodulation setup dialog is an instance of the Multi-channel setup dialog. It
allows you to set up one or more channels for intermodulation measurements on a
non-frequency converting DUT.
Meas softtool
To Next Page
Loading...
