GUI reference
R&S
®
ZNA
655User Manual 1178.6462.02 ─ 29
Delete Channel
Deletes the current channel including all the traces assigned to it and removes all dis-
play elements related to the channel from the diagram area. "Delete Channel" is dis-
abled if the recall set contains only one channel: In manual control, each recall set
must contain at least one diagram area with one channel and one trace.
Tips: Use the "Undo" function to restore a channel that was unintentionally deleted.
Remote command:
CONFigure:CHANnel<Ch>[:STATe] OFF
Channel On
Toggles the measurement state of the active channel.
Remote command:
CONFigure:CHANnel<Ch>:MEASure[:STATe]
Only Active Channel On
If checked, only the active channel is measured; all other channels are switched off
temporarily and dynamically.
Temporarily means: If "Only Active Channel On" is unchecked, then all channels return
to their original Channel On state.
Dynamically means: If another channel becomes the active one, the firmware adjusts
the temporary ON/OFF state accordingly.
Remote command:
CONFigure:CHANnel:MEASure:ACTive[:STATe]
Fixture Simulator
The "Fixture Simulator" switch deactivates or activates the configured deembedding,
embedding, balanced ports, and port impedance settings for the selected channel.
When "Fixture Simulator" is deactivated:
●
All balanced ports are resolved to single ended ports
●
All port impedances are set to default
●
All de/embeddings are disabled
At the GUI, the "Balanced Ports" dialog and the de/embedding tabs and dock widgets
are disabled. Related remote commands generate an error.
When "Fixture Simulator" is reactivated, the situation before the deactivation is
restored.
Note: The "Offset" and "One Way Loss" settings are not affected by the "Fixture Simu-
lator" switch. Use the "All Compensation Off"/"All Compensation On" functions of the
"Fixture Compensation" dialog to de/activate these compensations as well (see Chap-
ter 5.14.2.2, "Fixture Compensation dialog", on page 719).
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:FSIMulator[:STATe]
5.12.1.2 Channel Manager dialog
The "Channel Manager" dialog allows you to rename channels and to change their
measurement state and sweep mode.
Channel Config softtool
To Next Page
Loading...
