GUI reference
R&S
®
ZNA
838User Manual 1178.6462.02 ─ 29
The table displays the faults of the active trace (in case it is a Distance to Fault
trace) .
Export to File... ← Contents
Opens a dialog that allows to export the (filtered) content of the fault list to an ASCII file
with configurable "Field Separator" and "Decimal Separator".
This CSV type file contains one line (terminated by CR+LF) per fault. With ";" as "Field
Separator" and "." as "Decimal Separator", the fault list of Figure 5-67 is exported to
1; Trc1; 457.2 mm; -8.56 dB
2; Trc1; 1.539 m; -9.24 dB
For an explanation of the possible filters, see "Contents" on page 837).
Tracking Enabled
If checked (default), the "Fault Table" on page 837 is cleared at every sweep start and
populated in real time. Uncheck "Tracking Enabled" to freeze the table contents.
5.18 Display softtool
The "Display" softtool provides all display settings and the functions for activating,
modifying and arranging different diagrams.
Access: System – [Display]
Related information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and diagrams", on page 108
●
Chapter 4.2.1, "Display elements of a diagram", on page 124
●
Chapter 3.3.5, "Handling diagrams, traces, and markers", on page 58
Display softtool
To Next Page
Loading...
