Rohde & Schwarz R&S ZNA Series - CALCulate:FMODel:DELT...

Command reference
R&S
®
ZNA
1023User Manual 1178.6462.02 ─ 29
Options: R&S ZNA-K220 | R&S ZNA-K230 | R&S ZNA-K210
Manual operation: See "Measure / Apply section" on page 763
CALCulate:FMODel:DEASsistant:SAMCoupon <Boolean>
For the deembedding assistant, this command defines whether only the left coupon
model is measured or loaded from file.
This simplification is allowed for two-sided DUTs using the same coupon model for the
left and right side (CALCulate:FMODel:DEASsistant:COUPon:LEFT|
RIGHt:TYPE).
Parameters:
<Boolean> ON (1) | OFF (0), where ON means only the left coupon model is
measured (CALCulate:FMODel:DEASsistant:COUPon:
LEFT:MEASure) or loaded from file (CALCulate:FMODel:
DEASsistant:COUPon:LEFT:FILE).
Options: R&S ZNA-K220 | R&S ZNA-K230 | R&S ZNA-K210
Manual operation: See "Use Same Coupon Left and Right" on page 760
CALCulate:FMODel:DEASsistant:TOOL <FixtureTool>
Selects the fixture modeling tool to be used in the deembedding assistant.
Parameters:
<FixtureTool> ISD | SFD | EZD
ISD
AtaiTec's In Situ De-Embedding tool
See Chapter 4.7.16, "In-situ de-embedding", on page 299
SFD
PacketMicro's Smart Fixture De-embedding tool
See Chapter 4.7.17, "Smart fixture de-embedding", on page 300
EZD
Eazy Deembedding based on IEEE 370
See Chapter 4.7.15, "Eazy de-embedding based on IEEE 370",
on page 298
Options:
R&S ZNA-K220 | R&S ZNA-K230 | R&S ZNA-K210
Manual operation: See "Fixture Tool" on page 727
CALCulate:FMODel:DELT...
Commands for Delta-L PCB characterization (see Chapter 4.7.18, "Delta-L 4.0 PCB
characterization", on page 300).
CALCulate:FMODel:DELT:DIRectory..............................................................................1024
CALCulate:FMODel:DELT:DIRectory:DEFault................................................................. 1025
CALCulate:FMODel:DELT:FREQuencies:CURRent?....................................................... 1025
SCPI command reference