GUI reference
R&S
®
ZNA
751User Manual 1178.6462.02 ─ 29
Ground Loop per Port Group
If selected, each port group (= DUT) can have its own ground loop deembedding and
embedding networks. Otherwise the same de-/embedding network is used for all active
ports.
The checkbox is only visible if the instrument supports multiple DUTs, which is the case
for 4-port R&S ZNA.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:GLOop:GROup
5.14.9 Differential Match tab
Allows you to specify a 2-port embedding network for the differential mode of a bal-
anced port.
Such a network is either defined
●
via its S-parameter stored in a two-port Touchstone file (*.s2p) or
●
by specifying the parameters of a "Shunt L, Shunt C" lumped element model
Use the complementary dock widget to access the balanced port configuration and to
activate or deactivate "Differential Match" embedding for selected balanced ports (see
Chapter 5.14.1.8, "Differential Match panel", on page 715).
Background information
Refer to Chapter 4.6.2.8, "Differential match embedding", on page 241.
Offset Embed softtool
To Next Page
Loading...
