Rohde & Schwarz R&S ZNA Series - CALCulate:FMODel:SFD...

Command reference
R&S
®
ZNA
1047User Manual 1178.6462.02 ─ 29
Parameters:
<Boolean>
Manual operation: See "Small Fixture" on page 740
CALCulate:FMODel:ISD:TRACe:COUPling <TraceCoupling>
Tells the ISD tool about coupling among lead-in traces.
Corresponds to the coupling batch mode parameter of the ISD tool.
Parameters:
<TraceCoupling> NONE | WEAK | STRong
NONE: no coupling.
WEAK: coupling will be extracted even if there are 2 ports
enabled on the test coupon
STRong: if the test coupon is a 4-port file, and there are two
ports to be extracted, the ISD tool will optimize odd- and even-
mode insertion losses
Manual operation: See "Trace Coupling" on page 739
CALCulate:FMODel:SFD...
Commands for PacketMicro's Smart Fixture De-embedding (SFD), see https://
www.packetmicro.com/Products/sfd-tool.html
CALCulate:FMODel:SFD:AUTO.................................................................................... 1047
CALCulate:FMODel:SFD:COUPon:MEASure..................................................................1048
CALCulate:FMODel:SFD:COUPon:MEASure:FILename.................................................. 1048
CALCulate:FMODel:SFD:COUPon:MEASure:FILename:CLEar........................................ 1048
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe]........................................................ 1048
CALCulate:FMODel:SFD:COUPon:TYPE....................................................................... 1049
CALCulate:FMODel:SFD:DIFFcfg..................................................................................1049
CALCulate:FMODel:SFD:DUT:MEASure........................................................................ 1049
CALCulate:FMODel:SFD:DUT:MEASure:FILename.........................................................1049
CALCulate:FMODel:SFD:DUT:MEASure:FILename:CLEar...............................................1050
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe]...............................................................1050
CALCulate:FMODel:SFD:IMPedance.............................................................................1050
CALCulate:FMODel:SFD:PRESet..................................................................................1050
CALCulate:FMODel:SFD:RUN:RUN.............................................................................. 1050
CALCulate:FMODel:SFD<Ph_pt>:RUN[:STATe].............................................................. 1051
CALCulate:FMODel:SFD:TOTaldiffcfg............................................................................ 1051
CALCulate:FMODel:SFD:AUTO <Boolean>
Enables/disables the impedance correction of the SFD tool.
This is a global setting.
SCPI command reference