Rohde & Schwarz R&S ZNA Series - Page 1048

Command reference
R&S
®
ZNA
1048User Manual 1178.6462.02 ─ 29
Duplicate of CALCulate:FMODel:SFD:IMPedance, kept for backward compatibility.
Parameters:
<Boolean> ON (1)
Impedance correction enabled
OFF (0)
Impedance correction disabled
Manual operation: See "Use Impedance Correction" on page 730
CALCulate:FMODel:SFD:COUPon:MEASure
For a fixture modeling with the SFD tool, this command starts the measurement of the
coupon at the active ports (see CALCulate:FMODel:SFD<Ph_pt>:COUPon[:
STATe]).
The coupon type can be selected using CALCulate:FMODel:SFD:COUPon:TYPE.
Usage:
Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 731
CALCulate:FMODel:SFD:COUPon:MEASure:FILename <String>
For a fixture modeling with the SFD tool, this command loads the coupon properties
from a Touchstone file.
The coupon type can be selected using CALCulate:FMODel:SFD:COUPon:TYPE.
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 732
CALCulate:FMODel:SFD:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using CALCulate:FMODel:SFD:COUPon:
MEASure:FILename.
Usage:
Event
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 732
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe] <Boolean>
For a fixture modeling with the SFD tool, this command allows to specify the ports to
which the test coupon is connected.
This has to be defined before measuring the test coupon (using CALCulate:FMODel:
SFD:DUT:MEASure).
SCPI command reference