Rohde & Schwarz R&S ZNA Series - Page 1050

Command reference
R&S
®
ZNA
1050User Manual 1178.6462.02 ─ 29
CALCulate:FMODel:SFD:DUT:MEASure:FILename:CLEar
Invalidates the file path previously set using CALCulate:FMODel:SFD:DUT:
MEASure:FILename.
Usage: Event
Manual operation: See "Load File" on page 733
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe] <Boolean>
For a fixture modeling with the SFD tool, this command allows to specify the ports to
which the test fixture is connected.
This has to be defined before measuring DUT + Fixture (using CALCulate:FMODel:
SFD:DUT:MEASure).
Suffix:
<Ph_pt>
.
Physical port number
Parameters:
<Boolean> 1 (ON, true) if the test fixture is connected to port <Ph_pt>, 0
(OFF, false) otherwise
Manual operation: See "Active" on page 733
CALCulate:FMODel:SFD:IMPedance <Boolean>
Enables/disables the impedance correction of the SFD tool.
This is a global setting.
Parameters:
<Boolean> ON (1)
Impedance correction enabled
OFF (0)
Impedance correction disabled
Manual operation: See "Use Impedance Correction" on page 730
CALCulate:FMODel:SFD:PRESet
Restores the global default settings of the SFD tool.
Usage:
Event
Manual operation: See "Reset to Default" on page 730
CALCulate:FMODel:SFD:RUN:RUN
Runs the SFD tool.
SCPI command reference