Rohde & Schwarz R&S ZNA Series - 7.3.15.5 SOURce:GROup...

Command reference
R&S
®
ZNA
1534User Manual 1178.6462.02 ─ 29
Manual operation: See "Port Power Offset" on page 631
7.3.15.5 SOURce:GROup...
The SOURce:GROup... commands define the group of (un-)used logical ports.
SOURce<Ch>:GROup<Grp>........................................................................................ 1534
SOURce<Ch>:GROup<Grp>:CLEar.............................................................................. 1534
SOURce<Ch>:GROup:COUNt?.....................................................................................1535
SOURce<Ch>:GROup<Grp>:NAME.............................................................................. 1535
SOURce<Ch>:GROup<Grp>:PORTs............................................................................. 1535
SOURce<Ch>:GROup<Grp>:PPORts............................................................................1536
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:CONDition......................................1536
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:BWFactor........................ 1538
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:DVALue........................... 1538
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:MOFFset:MODE............................. 1539
SOURce<Ch>:GROup<Grp>:SIMultaneous:FOFFset:STATe............................................ 1540
SOURce<Ch>:GROup<Grp> <arg0>, <arg1>
In "set direction" this command defines the set of active logical ports (the "master
group") as the continuous range from <log_port1> to <log_port2>, i.e. logical
ports outside this range are disabled.
In "get direction" it returns the minimum and maximum enabled logical port.
See SOURce<Ch>:LPORt<LogPt> on how to define logical ports.
Suffix:
<Ch>
.
Channel number.
<Grp> Port group number, must be 1 (or omitted).
Parameters:
<arg0>
<arg1> First and last logical port number in the port group. Must be
omitted if the command is used as a query.
Example: See SOURce<Ch>:LPORt<LogPt> on page 1598
SOURce<Ch>:GROup<Grp>:CLEar [<arg0>]
Dissolves port group <Grp> or all port groups created using SOURce<Ch>:
GROup<Grp> on page 1534 or SOURce<Ch>:GROup<Grp>:PPORts.
Suffix:
<Ch>
.
Channel number.
<Grp> Port group number.
This suffix is ignored: only <Grp>=1 is supported.
SCPI command reference