Rohde & Schwarz R&S ZNA Series - Page 1535

Command reference
R&S
®
ZNA
1535User Manual 1178.6462.02 ─ 29
Setting parameters:
<arg0> ALL
If ALL is specified, all port groups are dissolved and a default
port group 1, consisting of all available ports, is restored; the
<Grp> suffix is ignored.
If ALL is omitted, only the specified port group is dissolved,
except the deleted port group was the only one, in which case
again default port group 1 is restored. In case an undefined port
group number is used, the analyzer generates an error mes-
sage.
Example: See SOURce<Ch>:LPORt<LogPt> on page 1598
Usage: Setting only
SOURce<Ch>:GROup:COUNt?
Queries the number of port groups in channel no. <Ch>.
Suffix:
<Ch>
.
Channel number.
Example: See SOURce<Ch>:GROup<Grp> on page 1534
Usage: Query only
Manual operation: See "Controls and Functions" on page 684
SOURce<Ch>:GROup<Grp>:NAME <GroupName>
Sets/gets the name of port group <Grp>.
Suffix:
<Ch>
.
Channel number
<Grp> Port group number
Parameters:
<GroupName> Group name
Manual operation: See "Controls and Functions" on page 684
SOURce<Ch>:GROup<Grp>:PORTs <port0>[, <port1>[, ...]]
Defines the set of active logical ports (the "master group") as an arbitrary selection of
logical ports. The ports do not have to be numbered consecutively (as for port groups
defined via SOURce<Ch>:GROup<Grp>).
See SOURce<Ch>:LPORt<LogPt> on how to define logical ports.
Suffix:
<Ch>
.
Channel number.
<Grp> Port group number, must be 1 (or omitted).
SCPI command reference